In fact, the main strength of the company iBasso lies in the ability to create effective amplifiers. Their laptop solutions in this area a little bypassed by the massive attention, but it's actually a very good reason. Today, however, we are not talking about them, but the replacement module gain , plus as a bonus I'll tell you about their headphone cable CB13.
It So happened that the heroes of today's review with each other incompatible. Gorgeous copper-silver hybrid cord designed for amplifiers with balanced output, plug-in module AMP2 made «common» (I don't know any translation of the English term single-ended). And while alternative staffing balanced amplifier AMP1 AMP3 is already moving in my direction, to defer to another time the review of the cable I don't want to. Make him a separate article, perhaps, is also too wasteful. So I go «hybrid» the locomotive to this review, and since the arrival of the AMP3 — will experience it with him.
If we talk about the gain, iBasso've tried my best. Despite the «nebelnest», it uses Quad-channel architecture with separate ground that allows us to achieve separation of channels, comparable to balanced solutions. Don't skimp on the little things like capacitors Nichicon, fast OPAMP, and so on. Overall nice, not to bend the price , quite humanely against the price of the player.the
The unit is Shipped (well, where do without the story about it?) in a conventional box made of black cardboard, according to tradition iBasso covered by a paper tape with the model name. Inside the amplifier, replacement screws and screwdriver for installation.
Unlike the Fiio X7, the DX200 is not necessary to completely remove the screws for replacement, just loosen them 2-3 turns and gently pull out the module. Note that the DX200 housing made of two l-shaped ledge included in the groove of the amplifier, so do not use extra force. In General, the procedure is very simple, all you need is a little care.
After replacing the module it is necessary to carefully fix by tightening the screws back.
By the Way, I did not conduct strict timing needs work but with approximately AMP2 player works the same as with AMP1. I think it is due to the fact that the new unit of power very close to the old one.the
IBasso love to tell the users about the necessity of warming up their devices for hundreds of hours. The player even included a special transaction load to the afflicted audiophiles plenty to apropriate AMP1. I don't believe this warming, but it is strange that the developers have left buyers of the second module without specialdevice to warm (that comes with the player, made for a balanced 2.5 mm output). How to live, not warming up the amp is a mystery.
Since the miracle wire for heating the second module is not provided, I had to write a review on cold (sorry, the Internet is impossible to convey in text sarcastic tone).
I would very much laughed, if AMP2 was indistinguishable in sound from the «unit». In fact the complete amplifier DX200 are more than good, remove it from the balanced output and sell it for some money, giving «hearing» enjoy the different nuances of sound would be very impressive joke. Luckily, as cruel joke the developers did not, the difference is still noticeable (Yes, I've done a blind test to make sure that it is not self-deception, but without it the difference is audible).
I got the feeling that AMP2 was doing for all those who were dissatisfied neutral quality of the first amplifier and the resulting problems with poor quality material. Sound «two» a little softened and added a bit of warmth, shifting from «neutral-technical» «neutral-the music». Yes, I understand that «music» — is such a word-a filler, in which everybody contributes something of their own, but in this case we are talking about my understanding of the term unity and integrity of the filing, the physicality of the instruments is what gives this effect for me.
If you imagine some imaginary chart «easing» audio AMP2 AMP1 relatively, you get a little tilted to the right in a straight line. The greatest effect is observed on the lower half of the range, however, in any case can not be called great, as iBasso with their experience simply could not get it done quite so smoothly-muddy flow. The second amplification module more deep bass, while they are normally controlled, although I still remain of the opinion that the initial part of the sound range of individual styles is not only unnecessary, but also interferes with (of course, in portable equipment).
Midrange also served more wholly due to this, the player builds an imaginary scene a little less than AMP1, but it depends less on the quality of the recording. This is the main and practically the only change in the flow of this range, fortunately, iBasso have shown restraint and have not smoothed the midrange enough to significantly lose detail. So if you compare the separation of instruments, the elaboration of plans, a contrast — all this was very close to the AMP1.
The high-frequency range retain clarity and unvarnished flow, in favor of Vcforum here a little, removed the aggression of the attacks, but the player is still very critical to the quality of the records and delivers the RF, not trying to hide them. However, due to the increase in the lower ranges of the focus still shifts slightly, but it is solely the effect of perception.
Plus a single amplifier, and low noise. Of course, Andromeda (Ah, the Andromeda) will still make some noise, but to achieve the noise from the less sensitive headphones would be unrealistic.the
Bonus section of the review is devoted to the silver-copper hybrid cable from iBasso. Releasing and scheduling a few models, the company could not stay aside and not to indulge lovers of audiophile cables. They did CB12 wire of silver plated copper and harsh as Sveaborg option from pure copper and silver wires CB13. In this cable the company's products is significantly less than companies dedicated exclusively to the wires. For «powerbrake».
In my opinion, the main characteristic of a cable is its convenience. Even if it's made from a hybrid of vibranium with unobtanium — if the wire is uncomfortable, to sense from it is not. CB13, despite the thickness, is very comfortable: soft, not hardening in the cold, not prone to tangling. Due to the weight, despite the absence -, of the microphone the effect is not pronounced. The wire also looks fantastic — bright, solid, with quality connectors (used MMCX 2.5 mm balanced TRRS, respectively).
And, of course, sound. If you still used the 3.5 mm output of your DX200 — definitely go for a balance, even if you don't want to spend money on the CB13, I think, even CB12 will be more than enough to get a noticeable difference in the sound. I was wondering whether there is an effect from the CB13, so I compared it with a few simple balance wires that I have in my collection (unfortunately, I have no CB12). To make this as objective, I conducted a blind test with an assistant, and there is a difference (albeit very small), this wire gives you a more focused bass and a little better attack on the treble. The effect is not great, but still I heard a difference in 14 of the 16 tests. So, if you say «» — I remain sceptical on account of «huge difference», which supposedly give leads to IEM (well, if there is not clocked something with the impedance of the cable), but small nuances «in particular» is. Although there is a logical question, especially against the background of cost IT03 themselves. I think CB13 in iBasso has in store for future, more expensive models.the
Very good amplifier that offers exactly what many are not enough, AMP1 allows to obtain less capricious flow, although in some cases, AMP1 will be at least as good, if not better. I look forward to AMP3 and the release of the recently announced AMP4....
When you meet the sound and advanced technology, it turns out something interesting. the Market for Bluetooth headphones with active noise cancellation at a price of about 20,000 rubles is developing rapidly. Bose may have been a pioneer in this segm...
Under water can be found anywhere. Even the sounds. Water generally is a very interesting element. Due to its properties, it very well conveys the sound. To understand this process it is enough to remember that sound — it's just a vibration env...
Among lovers of quality sound it is quite widely believed that listening to music you only need use a separate player and headphones, are specifically matched to him. However, the cost of such a set usually varies from about 30 thousand rubles to inf...
the Company ZMF has long established itself on the market of personal audio as «boutique» manufacturer with their signature sound. After on the basis of the emitters from the Fostex T50RP, the company decided to make the...
Those who caught the dynamic head of Platinum Audio in the 90-ies of the last century, must have heard the name of the outstanding engineer Dan Clark, who developed the electronic apparatus in the world of Hi-End for many years. S...
anything in a world made up of little things, and portable audio equipment is no exception. Sometimes some small details can change the impression of a decent model with quality sound and to condemn it to obscurity. It was about t...