Printed on a 3D printer tibia implanted in the patient

Date:

2017-09-10 21:30:04

Views:

1587

Rating:

1Like 0Dislike

Share:

Printed on a 3D printer tibia implanted in the patient

Experimental surgery helped 27-year-old Australian to save the leg. Reuben Lighter suffered from a serious form of osteomyelitis and he was threatened with amputation, but the doctors encouraged him to try a new method, previously tested only on animals. As a result, surgeons implanted him in the leg the tibia, printed on a 3D printer.

It was First created three-dimensional model of the tibia of the patient, then she was sent to Singapore, where the prosthesis is made of biocompatible polymer. For the successful completion of implantation the doctors had to carry out five operations. In the first of them from the tissues drained the pus, and the next four were needed for successful completion of the operation, just set the 3D prosthesis in place of bone will not work.

The New bone covered the blood vessels and tissues taken from the patient's tibia and left knee — now they are starting to grow around the new bones. Doctors believe that over time, the tissue will be able to recreate new bone, but it will take a lot of time — a year and a half. While Reuben you can't go around alarming pace.

This is not the first case of replacement of the bone of the patient on a 3D prosthesis. Previously, China held , during which the patient was replaced a few cervical vertebrae prostheses created with 3D printer.

Recommended

The coronavirus has mutated into 30 new strains

The coronavirus has mutated into 30 new strains

While coronavirus Apocalypse slowly but inevitably becomes routine, the virus SARS-CoV-2 continues to evolve. And, unfortunately, he was good at it. Writes , with reference to the South China Morning Post reports that new studies show that the virus ...

In the United States recognized that the ventilator dies 88% of patients with coronavirus

In the United States recognized that the ventilator dies 88% of patients with coronavirus

When the world is raging coronavirus that causes pneumonia and kills people, the only solution is intensive care. If this is not done, the victims will be very much. Today for severe patients there is only one solution — connected to the appara...

Can a transfusion of blood plasma to cure the coronavirus?

Can a transfusion of blood plasma to cure the coronavirus?

Typically, vaccination involves the introduction into the organism of the weakened or killed microorganisms (viruses) designed to create a strong immunity to possible future infectious diseases — that is, for selection of antibodies. But what i...

Comments (0)

This article has no comment, be the first!

Add comment

Related News

How to make the medicines more effective?

How to make the medicines more effective?

One of the main problems of the effective action of drugs is that while they «travel» the body of the substances just destroyed our defense system. In addition, medications are often toxic and cause no little harm. Has l...

In the U.S. propose to use the Zeke virus to fight cancer

In the U.S. propose to use the Zeke virus to fight cancer

One of the main problems in the treatment of brain tumors is poor accessibility to medicines (because the brain is protected by blood-brain barrier), so for surgical intervention because of the danger of damaging vital centers. Bu...

Modern tests to determine cancer are not effective?

Modern tests to determine cancer are not effective?

Modern methods of diagnosis of this deadly disease as cancer are not informative enough. The disease is usually detected at a late stage. One of the most common ways to recognize cancer is the identification of tumor markers (if s...